ONE YEAR/6000 MILES (WHICHEVER COMES FIRST)

ENGINE OIL

Replace

OIL FILTER

Replace

COOLANT

Inspect, top off using an approved coolant.

TRANSMISSION/FINAL DRIVE OIL

Replace

SPARK PLUGS

Inspect /replace

VALVES

Inspect and adjust as required

CARBURETOR/THROTTLE BODY

Synchronize as needed

IDLE SPEED

Inspect – adjust

FUEL LINES

Inspect lines and clamps; replace chafed lines, tighten clamps.

FUEL FILTER

Inspect/replace as required

AIR FILTER

Inspect/clean or replace as required

THROTTLE/THROTTLE CABLES

Inspect and lubricate cables, check operation, adjust free play

CHOKE/FAST IDLE CONTROL

Inspect operation. Lubricate and adjust linkage as needed

CLUTCH/CLUTCH CABLE

Inspect cable adjustment. Lubricate cable and clutch lever pivot

STEERING HEAD BEARING ADJUSTMENT

Inspect and adjust

SWING ARM AND LINKAGE

Inspect and lubricate

FORK SEALS

Inspect for leaks or other damage

REAR SHOCKS

Inspect for leaks, worn bushings.

DRIVE CHAIN

Inspect, lubricate, adjust

DRIVE BELT

Inspect, check tension

DRIVE SHAFT

Replace oil (if applicable)

BRAKE FLUID

Verify level; if contaminated, replace.

BRAKE PADS

Inspect/replace

BRAKE CALIPERS

Wrench-check mounting hardware, check for leaks/chafed hoses or torn dust boots. Make sure all pistons are free.

BRAKE ROTORS

Wrench-check mounting hardware, look for scoring or other damage

BRAKE MASTER CYLINDERS

Inspect for leaks.

WHEELS

Inspect and adjust spokes, Inspect wheel bearings for play. Inspect wheel seals for leakage. Inspect wheel alignment.

TIRE CONDITION AND PRESSURE

Inspect and adjust. Replace worn or damaged tires. (Obviously, tires should be replaced whenever they’re worn out, but they’re often overlooked when the bike is infrequently ridden.)

ENGINE AND FRAME BOLTS

Visual inspect and wrench check. Make certain all appropriate cotter pins/lock tabs are in place and bent over.

LIGHTS

Inspect operation

BATTERY AND CHARGING SYSTEM

Top off battery, check cable terminals, check charge rate.